Nissan Maxima:Learn How to Replace and Tighten Coolant Hose (DIY)

Add comments

28-07-07_1744.jpg
Photo by iandraz
It’s part of normal maintenance on Nissan Maxima to replace the coolant hoses. You are advised to change your automotive hoses once every four years or whenever you see them show signs of wear. Located at the front of the engine block, Nissan Maxima has two engine block drain plugs in order to speed the draining process of the radiator.

Here are the steps to maintain your Maxima’s Coolant Hoses:

1. Turn to high heat the Maxima’s manual heat control. For automatic controls it must be set to maximum. Leave the engine for at least one hour to cool down after driving. After this, remove the radiator cap.

Position a catch can or a bucket under the drain plug and don’t forget to remove enough coolant in order to minimize leaks during hoses removal.

Detach the engine block draing plugs, it’s done to make radiator drain quicker during the replacement of lower hose.

2. Loosen your Maxima’s hose clamps by using a pair of pliers. Now slide the clamp to center of your hose. Twist or pull the hose until it’s detached from the fitting. Cut difficult hoses using a knife and make sure you peel the rubber at the end back over the nipple.

3. Take the new hose and prepare it by first dipping its ends in clean coolant. Now slide your clamps onto the new hose and push your hose onto its fitting. If one end feels too tight you may turn the hose around.

4. Tighten your clamps using a pair of pliers. Double check to make sure that the clamp is positioned inside the clamp dimple. Make sure the engine block and the drain plug are tight enough. Replace the radiator cap and refill your radiator with coolant.

5. Start your Maxima, and look for leaks around the hose ends and drain plugs. Once the engine has circulated, add an appropriate amount of coolant.


RADIATOR COOLANT OVERFLOW TANK for NISSAN Maxima (1995-1999), 1995 1996 1997 1998 1999 95 96 97 98 99




COOL-AIDE COOLANT – MAXIMA RACING OIL -




MAXIMA RACING OIL COOLANOL64 OZ. – 82964

Goodyear 62473 Radiator Coolant Hose


Watch The Video Below and learn how to replace car radiator hoses. Don’t forget to place a pan underneath your car to catch leaks from radiator hoses. (Only For Free Registered Users)

[metacafe]http://www.metacafe.com/watch/yt-YJQbOUj44gY/how_to_replace_a_car_radiator_how_to_remove_car_radiator_hoses/[/metacafe]


Watch The Video Below and Learn How to replace your leaking radiator hoses. You’ll need a flathead screwdriver and a Philips head screwdriver, and don’t forget a good pair of pliers.

[metacafe]http://www.metacafe.com/watch/yt-BhhG1RT7mQw/auto_repair_maintenance_how_to_replace_a_leaking_radiator_hose/[/metacafe]

K5735SE9R8XV

Nissan Maxima July 16th 2010

2 Responses to “Nissan Maxima:Learn How to Replace and Tighten Coolant Hose (DIY)”

  1. Alan Says:

    Very thorough explanation. It is even more valuable, since there are not to many tutorials like this for Maxima.
    Thanks much.

  2. Sterling Napa Valley Cabernet Sauvignon Says:

    Very good – I really should undoubtedly pronounce, impressed with your website. I had no trouble navigating via all tabs and related information ended up being truly easy to do to access. I lately discovered what I hoped for before you know it at all. Quite unusual. Is likely to appreciate it for those who add forums or something, internet web site theme . a tones way for your customer to communicate. Excellent task.

Leave a Reply